Download assembly instructions 
|
|
Assemble on a drop sheet or similar. Spray a coating of supplied Lanotec to interiors of tubes.
Spread out a side panel with hems facing up.
|
|
|
Push tubes E and D through the webbing loops. Make sure the threaded holes in tube E are also facing up. |
|
|
Join tubes E and D with the long screws
Tip: Leave all screws loose until all are threaded.
|
|
|
Join tubes A, B and C with plastic joiners K. Ensure angled end of tube B meets with tube E and that the cradle on plastic joiners are facing up.
|
|
|
Join both sections to form side frame with (long) screws N and leave all screws loose until all in. When all screws are in - tighten. |
|
|
Attach Velcro tabs to frame to complete the side panel, then repeat process to complete opposite side panel. |
|
|
Attach gussets to each end of tube F (rectangular cross section)
It is important to leave all screws loose! Have a friend hold side panels while you attach tube F.
|
 |
Thread tube I through webbing loops in panel Q. Ensure that the hem is facing in and with the help of your friend, join tube I to the side panels with the medium sized screws M. |
 |
Preparing front panel.
|
 |
Join tube H between side frames ensuring plastic knobs are facing "out". Do not over tighten screws.
|
 |
Front panel almost complete.
|
 |
Fasten the Velcro tabs to tube H and attach zip ties to corners of panel Q – do not over tighten.
|
 |
Place both tubes G into cradles provided. |
 |
At this point you may wish to move the Pump Shack over you pool filter. |
.jpg) |
Attach fabric cover along top rear edge, then evenly tension shock cord to the outer 2 knobs and the middle 2 knobs. The other 2 knobs are for taking up slack as the shock cord ages.
|
pool filter cover, pool equipment cover, pool pump cover, pool pump hut, pool filter house, pool filtration cover, pool pump house, pool filter hut, pool pump shed, pool filter shed, pool equipment shed, pool equipment house.
|
